Photography Simon 29th February 2016 whiteout
background and gels
Whiteout- the background is completely white with no changes
in tone or shadows.
There are two different flash heads that are usually used in
the studio which are the 1000DX light and the 500DX light.
The 1000 gives out more light and is good for bounce
lighting or when using a soft box, however it is heavier than the 500.
The 500 is less powerful but is lighter than the 1000.
When using a softbox attach the flash head to the softbox
before putting the flash head on the stand.
The 1000 is the best flash head to
use with a soft box especially if the soft box is big, in which case you will
also need to use a larger stand.
Always use a light metre to create a whiteout making sure
the flash setting is on C and the ISO is 100. For whiteout you want the aperture
to be F8.
To create whiteout you will need a softbox light which will
be the key light and two smaller lights with spill kill attachments on them.
Set up the softbox light as you normally would, pointing
towards the backdrop and towards the model. Have the other two lights, one
either side of the model but slightly behind the model and pointing at the
backdrop, these two lights can be 500 instead of 1000.To check the angle is right
make sure that the model cannot see the silver inside of the two smaller lights
from where they are sitting so that you know there will be no spill on them. If
they can see if the either change the angle of the lights or ask the model to
move forward.
If the aperture on the camera is 8 then you need to put the
other two lights one level higher which is 11. If you are shooting at 5.6 one
level brighter is 8.
The cell button on the camera needs to be on for both of the
two smaller lights so that they flash at the same time as the key light.
Make sure the two smaller lights are not too close to the
background so that the background is lit evenly. As a last resort if the model
is still getting lit from the two lights than put foam boards between them and
the light.
In the photographs above we tried to create a completely white background. In some of the photographs there re areas of grey so we moved the lights to try and stop this happening.
In the photographs above we used blue and red gels and tried to achieve different amounts and shades of the different colours. We also tried them against different background colours. When using gels a good background to use is grey as you can use any gel on it. As the power of the light increases the colour of the light from the gel is paler. If you want the background to be evenly one colour then move the light with the gel on further away from the background. If you want there to be a hotspot of colour then move the gel light closer to the background. The gels can be attached using bulldog clips. Press the spill kill attachment into the back of the gel holder and open the barn doors of the attachment.
No comments:
Post a Comment